raceking46

I don't have any carpet or door panels on the car yet so it is a bit noisy but I'm sure with dynamat and carpet etc. it wouldn't be too bad.

HERE YOU GO! THESE ARE THE ONLY ONES I GOT. I won't be able to get up on the lift any time soon so I hope this works for who ever was looking for em.

I have a BOP 10 Bolt in mine with 355 and a 4 spd trans from a corvette I'm runnin about 3k RPM at 60mph. If that helps

i don't know how to tell the difference. Does the BOP have the axle bearings pressed on the axles cuz mine does and the ring gear bolts are 7/16 left hand thread.

trying to rebuild my rearend. Its an 8.2 10 bolt and i'm having nothing but trouble. bought a posi unit on ebay wrong size ring gear bolt holes. bought a bearing kit for 8.2 and the shims aren't right and neither are the pinion seal or nut. I bought the chevy stuff not the BOP so I'm not sure what the issue is here unless someone put a BOP 8.2 in my car b4 I got it.

I swapped out my automatic for a T10 4spd and now my speedo cable is too short and the spot where it goes in the tranny is on the other side. Do I need to order a custom cable or is this a common fix?

Heres the video of the Signals you guys asked for. I did end up using a plug with a resistor wired into it for the LED signals on the front. You Tube Signal Video

I've thrown around the idea of making spoiler peices for the fender extensions but I'm pretty sure the nascar montes only had the center section. As far as mounting I would have to insert studds into the fiberglass during the molding process. I welded them on the metal one. The nice part about only doing the center section is that the spoiler would then work on the chevelle and skylark as well. The cost would really depend on the cost of supplies and time it would take to make them. Of course the first one is the hardest. I guess the question is whether or not theres enough market for it?

I made the spoiler but I've been thinking about using it as a plug to make a mold for fiberglass and selling them since no one does... haven't really made a decision on that yet.

Got the LED Tail lights hooked up and mounted the rear bumper. [img:left][/img]

Has anyone installed the Trim Parts LED tail light kit??? I can't seem to get it to work.

Got the bumper mounted up today wiring starts friday

I didn't even think about the flash speed I'll have to tackle that problem in a week or so when I get to the wiring. I couldn't get a good seal between the old lense and new lense so it was just easier to cut out the old lense and split the ring so it fit in the grove on the new lights. I was afraid of moisture forming between the lenses if I put them on top of each other. It would depend on the set of lights purchased as how to mate the old to the new. I'm sure with some fabrication you could probably use the entire peice so that the light looked stock from the outside.

Warning!!! OEM part mutilation!!!! My old signals where corroded beyond use and I had to think of something so I decided to modify what was left of mine. I started with these lights from ebay. ebay and then