Boots Posted July 12, 2014 Share Posted July 12, 2014 hello all..has wondering if anyone had any pics of how they modified a chevelle outer wheelhouse to fit the 1/4...thanks Link to comment Share on other sites More sharing options...
Rob Peters Posted July 12, 2014 Share Posted July 12, 2014 Here is a link that may help you out. check this post Rob Link to comment Share on other sites More sharing options...
Boots Posted July 12, 2014 Author Share Posted July 12, 2014 thanks !!! Link to comment Share on other sites More sharing options...
Daryl Posted July 14, 2014 Share Posted July 14, 2014 I know I read some where that the previous generation chevelle metal was less work "prior 68". Can any one verify that? Link to comment Share on other sites More sharing options...
Boots Posted July 15, 2014 Author Share Posted July 15, 2014 I have the 70 chevelle ones...AND just found out I'm laid off for a bit, so now I have time to hammer em into shape Link to comment Share on other sites More sharing options...
restodude Posted October 12, 2015 Share Posted October 12, 2015 I just made mine from sheetmetal , it was only rusted where it connected to the quarter panel , pretty simple if you get in the wheel housing and start bending , piece if sheetmetal ,bent into angle iron shape , just match it up with the quarter off, then when you install the quarter panel you weld it in last , you will already have the basic shape, bend , cut , weld , grind ..... Easy .... Link to comment Share on other sites More sharing options...
Rob Peters Posted February 28, 2019 Share Posted February 28, 2019 The First Gen Monte outer wheel houses are now being reproduced. rob Link to comment Share on other sites More sharing options...
Recommended Posts