Soler89 Posted December 31, 2017 Share Posted December 31, 2017 As a few of you know, I recently acquired some Monte parts. One of them was a qjet. My question is, would the qjet fit on top of the intake? The qjet did come with a spacer that's shaped like the bottom of the carb. (idk what the proper term is for it.) Quote Link to comment Share on other sites More sharing options...
Sam (Bones) Posted December 31, 2017 Share Posted December 31, 2017 it depends....your intake maybe for a square bore carb, so you would need an adapter (square bore to a spread bore) Quote Link to comment Share on other sites More sharing options...
Blackhawk Posted December 31, 2017 Share Posted December 31, 2017 As a few of you know, I recently acquired some Monte parts. One of them was a qjet. My question is, would the qjet fit on top of the intake? The qjet did come with a spacer that's shaped like the bottom of the carb. (idk what the proper term is for it.) Between the carburetor portion and the thermostat portion of the intake there should be writing cast into the intake; it will either say 'PERFORMER RPM' or 'PERFORMER RPM Q-JET'. This will tell you if the Q-jet will fit directly or if you need a spacer. If it's a square bore intake, I would look to sell it and buy an intake made for the Q-jet. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.