Crank Posted June 3, 2018 Share Posted June 3, 2018 I’m installing the shift works gauges and tac this morning, and noticed I am missing a transition piece between the heater outlet and the plastic defrost vent for the windshield. Can someone help me please! What does it look like? Possibly a picture? Was hoping to complete this nasty job today Quote Link to comment Share on other sites More sharing options...
stangeba Posted June 3, 2018 Share Posted June 3, 2018 Like this? From my 71, NO A/C when I replaced the heater core 7 years ago. (Snowball on that project!!!!!) Bruce Quote Link to comment Share on other sites More sharing options...
RealRed70 Posted June 3, 2018 Share Posted June 3, 2018 You already have what you need, other than the fastener that is missing. See that small hole in the heater box just below that steel tab with a larger hole in it. you need to put a fastener in there to connect the plastic duct to the heater box. There is always a gap down there. That does not get sealed up. 1 Quote Link to comment Share on other sites More sharing options...
Crank Posted June 5, 2018 Author Share Posted June 5, 2018 You don’t happen to have a picture of the fastener do you?? I was thinking just a couple tabs made out of 1” flat, one at each end. Quote Link to comment Share on other sites More sharing options...
RealRed70 Posted June 5, 2018 Share Posted June 5, 2018 Yes, I should have a fastener. I can post a picture tomorrow morning. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.