Leaderboard

Just little stuff today, had to reverse the valve covers because the oil fill cap was directly under the a/c bracket going to the manifold. Installed the vacuum port fitting for the brakes and trans in the manifold. Had to get a special fitting as the stock original one couldn't be used because what i'll call the "riser" where the carb goes was to close to the vac port and couldn't be installed. Joe helped me with my lower a/c bracket issue (different thread) this am so that was another accomplishment.

Nice going. I wish always I see someone lift their Monte off the frame that I should of done that years ago. Are those yellow rollers from Harbor Freight? Do they work okay? Carl

that tweak on the side is probably somone jacked it up there. the rear is probably from a poorly placed bumber jack or the wrong jack. someone on this group has measurements tou can take to make sure it is not a problem

I was able to get the cable changed out yesterday evening. Turns out the nylon retainer was still in the pedal. I knew the hole in the pedal wasn't big enough, that is because the retainer was still in place. Good thing I bought a new one because the old retainer disintegrated when I removed it.