Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 05/31/2020 in all areas

  1. Just an overview on spark plugs for me, remember i'm using 13/16 plugs. #8 works for me from underneath, even with the starter installed. #5 even with the shorter wallymart socket with the rubber grommet out is super snug on removal at the last few turns. I liked the "lawn mower socket" because once I started the thread it was easy to turn till I needed to tighten with a socket. On Daves oil filter question, while there is no clearance issue installed I wanted to fill the filter up when I was priming the engine. But I could only get it out past the headers sideways so was in no mood to spill oil all over myself and more lol. I like Joe's Thermaflect tape idea, I'll order some myself on the next summit order. I'm sure I'll need something else next week lol. Oh, and this thing is LOUD with open headers in my garage.
    2 points
  2. Glass is out, handles off. Doused all the internals in penetrating oil. They seem to be in good working order, so they shouldn't have to come out. Next step is to strip them...and probably find a better storage space for glass...definitely going to get talked to if I leave it here!
    1 point
  3. Drilled holes in the $1400 ARH headers today... The girlfriend cringed more than I did .
    1 point
  4. Not really something I did TO the monte, but more what I did FOR it. The donor went under the knife, and after a lot of cussing, we got her out. I tell you what, it didn't want to come out! Grandpa said he's pulled 1000s of engines, and nothing has pissed him off this much!
    1 point
×
×
  • Create New...