Regmon

Hello. Has anyone used a umi 4034-B reas sway bar and had issues with it not fitting between the lower control arms? I have a set of umi 4024-B non-adjustabe boxed lower control arms and I just purchased a umi rear sway bar 4034-B and I could not get them between the control arms, they seemed to be about a 1/2" to wide. Has anyone else run into the before. Thanks

very nice...

Watch where you get your quarter panels from. I got mine from OPGI. My body guy said the line in the quarter ran off where the quarter extension meet the quarter panel. I don't know if it was true, but I was pissed.. but in the end he did get it right.

I to have received that email and I renewed back in January. My credit card had the charge on it. What's up with that?

I got my pod for a 72 from Summit and it was the restoparts brand.. it was very good quality.

Good day..just thought everyone might like this. https://youtu.be/CAggDusGPNY

I learned something new today.Thanks for your input...

I just finished the idiot light to gauge conversion and eliminate that part. So what you saying is if i have a floor shift column and attatch the the back drive the bowl would move just like the bowl on a column shift column..?

ANOTHER QUESTION..IF I CHANGE THE COLUMN TO A FLOOR SHIFT COLUMN, THEN I WOULD HAVE TO CHANGE THE NEUTRAL SAFETY SWITCH & BACK UP LIGHTS AND EVERY THING ELSE TO THE FLOOR SHIFT SET UP CORRECT? RIGHT NOW I AM STILL USING THE COLUMN SHIFT COLUMN AND DIDN'T NEED TO CHANGE ANY OF THE WIRING FOR THAT.. WOULD BE BETTER TO JUST CUT OFF THE BOSS OR TRY TO GET A NON-TILT FLOOR SHIFT BOWL AND TRY TO MAKE IT WORK WITH MY EXISTING COLUMN..WHAT DOES EVERYONE THINK ABOUT THAT?

yes bruce it really is a small world...gilbert is not far from my house...by the way you have a fantastic monte!!! are you from this area? and was the monte from here to?

Thomas, who is the company that has a sleeve for the tilt column conversion?

my column is a non-tilt but if anyone has a tilt floor shift column i would be open to discuss. Larry i sent you a PM.

Hello everyone. I have a question on my steering column, I changed mine from column shift to floor shift. and was looking for a replacement sleeve without the shift handle piece to replace my existing sleeve and make it look like a original floor shift column. I seen some videos where the piece is removed by cutting it off and doing some patch work to fill in the area. but before i dive into something like that i was checking to see if there was a replacement out there that would work, or if anybody has another solution without changing out the complete column. thanks for reading my post. any advise is appreciated.

Good day everyone...re-doing the dash and noticed the heater/ac duct pipe is in bad shape. looks to be some kind of fabric hose with a spiral wire for support. the section by the pass. side measured 3". does anybody have suggestions for replacement hose & where to get it. thanks for any help you can provide.

Thanks for the help. I got them out and installed the other's to there locations...