sqzboxman78

Thanks Y'all for your kind words! I keep looking for light at the end of the tunnel, can't wait for the final creation! Thanks for the info on the drains, 420ponies and Crom Cruach! I appreciate it!

Thank you sir!

Good morning Y'all! This has been a fun and challenging project especially when it's DIY..(aren't they all). I cut out my old floor due to rust issues and replaced with a used rear clip. So, I uploaded some pictures to share progress, let me know what Y'all think. I need to add the inner quarter panel lips for the trunk lid to sit on, but I'm trying to figure out the rain gutter situation. Ultimately, fabricating to the original set up is ideal, but if there are any suggestions out there, i would sure appreciate it. Also, I've seen somewhere on here or on line, a rain drain piece with a hose attached. I'd like to integrate that under the rear window molding. Anyone know where I can find those?

Nice work btw! This is where I'm at..I was thinking bondo could cover the gaps but I'd like to keep it original..

THAT'S WHAT I'M TALKING ABOUT!! Those look Awesome and less stressful to install! Those are exactly what I need, thanks for sharing! AMD huh, I'll have to check them out. I was looking at one off of OPGI.

Thanks guys! I was hoping it had the top body piece that lines up with the trunk lid. I may have to get the full panel..

Good afternoon Y'all! Has anyone installed these panels? I've had to do some patch repair and I'm considering replacing the panels. I've seen these on a few different websites but no one shows a picture of the top view and/or door jam. Can anyone show me how "complete" this piece is?

AWESOME! Thank you for the information sir!

Good morning Y'all! I just replaced the rear section of my 72, new floor, rear tail assembly. I wasn't able to find my fuel sender wire. As I'm going back to repairing my taillight harness I started looking for it and the only wire going back to the firewall was my fuel pump wire. Is the sender "brown" wire part of the tail light harness? i was going to order a replacement sender wire and it seemed a little short. I might run a wire direct from the gauge to the sender to cure the problem, but if I can find where the sender wire is coming from, that would be helpful...suggestions?

Thanks..

Any luck finding those clips? I need to replace mine. They are a rectangular plastic strip that lock on a metal tang, if you will..