I'm at the beginning stages of my project 350 engine build, I'm confused as to what I should do. I have the block #3970010 and I'm taking it in to get cleaned and inspected. I'm not looking to turn it into a stroker but I would like 400-425 hp. Could this be done with this block? It's bone stock, never been bored etc. Where do I start after the cleaning and inspection? Could it be bored out? I have no clue where to go, its not something I want done right away due to budget restraints but I'd like to get a good build eventually. Any advice? I have an Edelbrock Performer intake already and a 650 Edelbrock carb, just need to figure out the right crank and cam etc.