Jump to content

Fgmcc grille badge


Recommended Posts

It should have comexwith the 2 studs, I used a piece of 1 inch aluminum stock I got at hardware store. The reason I used aluminum uas to elongate the holes a little because the studs were in a little bit of an angle. I still have it around here somewhere if you need a piece of it.

Link to comment
Share on other sites

I used some really large washers from the hardware store which works on the 70/71 grilles pretty well. For a 72 grille you likely need to do a larger piece of metal/plastic as the grille openings are larger.

  • Like 1
Link to comment
Share on other sites

28 minutes ago, willie said:

Goes faster than you think Glen!!

I’ll bet it does. And at least I’ll be entertained by the car of characters here in the meantime. 

  • Like 2
Link to comment
Share on other sites

I used a piece of 3/8 inch plexiglass from an old wind chime. it was a round piece a little smaller than badge, drilled easy so i could elongate the holes.

  • Like 2
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...