Jump to content

A note on stamping engines


Recommended Posts

Just a note about stamping engines; Chevrolet used a broaching process to deck their blocks. This process is very different from the resurfacing machines used in most machine shops, which are usually rotary cutters, like a van norman.

These machines leave a very different finish on the deck surface, which will be seen by those who know what to look for. I have had engine pads inspected for this by potential buyers.

If somebody decked my block, I'd want to know about it. Years from now, it could cause problems.

Link to post
Share on other sites
×
×
  • Create New...