Tim972

I did end up ordering some from NPD

Ok, I will check into that. I just wanted to make sure I wasn’t missing them listed online somewhere. Thanks

I’m in search of a set of seat back upholstery buttons for my black 72’ vinyl bucket seats. Are they available new? Or do you have to find a used set? I don’t need the seat covers, just the vinyl buttons. Thanks

Right on , thanks 👍

I have a 72’ with non working A/C. Id like to get some fresh air inside until I get aftermarket air. In the kick panel area, can I remove the vacuum actuated door on pass side and the block off plate on the driver side and add the non A/C kick panels and be good to go? Or what else needs to be done? Thanks

Very nice, Chevelle sounds great 👌

I bought a set of American Racing headers, which I’ll hopefully be installing soon. Since some of you guys have been running them for a few years now, do you have any advice on cleaning or maintaining them, or anything I should do prior to installation? I read an article about spraying the inside of stainless steel headers with VHT silver ceramic paint to prevent the outside from bluing, not sure how well that works. Thanks 👍

I appreciate you checking, thanks again

cbolt thank you. Did you replace every bulb, as in turn signal & bright indicators, etc with the same led? I see they do have other options for those, It looks like they’re slightly dimmer bulbs. For a 72’, I assumed the color they call natural would be the normal white ?

Superbrite led’s website claims there 194 replacements for the instrument cluster are dimmable, can anyone verify they will dim correctly ? I’m not fond of excessively bright dash lights, but I like the thought of lower current draw and less heat on the circuit board. Thanks 👍

Very cool 👍

Thank you, that definitely helps. Mines about 12 5/8” - 12 3/4”. I get exactly 2” to the back of both wheels from the inner fender by the frame, so I’m guessing my quarters are a little wider on the lip.

I’ve been looking for a couple measurements I haven’t been able to locate. — How wide is the wheel well lip on a factory quarter panel? Are aftermarket quarters typically wider there ? — What is the dimension from inside that wheel well lip to the inner fender near the frame? Thanks 👍

My intention was to do the floor shift conversion, back drive the column and eliminate the shift indicator or cover it somehow. Probably end up just blacking it out. I thought maybe aftermarket might make a plug or something similar to fill the hole.

I was hoping to reuse the original, to retain the odometer reading.