tonym0828 Posted February 8, 2015 Posted February 8, 2015 Anyone tell how difficult changing the motor mounts on 350 in a 72 is on the garage floor. I looked under and I am worried about having enough clearance to get them out. has headers on it. Quote
mikenewman Posted February 8, 2015 Posted February 8, 2015 they are not hard at all. put car on jack stands put a wide board on the floor jack under the oil pan. put small amount of presure on jack. remove through bolts. raise the motor up gently watching the distributor cap. remove bolts off motor. repeet in reverse to install Quote
cny first gen 71 Posted February 8, 2015 Posted February 8, 2015 Yea what he said, air tools make it much easier too. Quote
502ci Posted February 9, 2015 Posted February 9, 2015 Like it was already mentioned watch the distributer cap...might even want to remove it if you have an aftermarket one that has a large cap. It doesn't take much to have a little bit of pressure on it from the firewall and it will crack. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.