Enigmatic Posted September 12, 2015 Posted September 12, 2015 Ok...about to start putting my dash back together and have converted the dash lights to LED. My question is...is there a way to power up the gauge cluster without installing it to the dash to make sure the LED's are in correctly. I understand that if you put them in upside down then will not power up. I would rather have this taken care of before I install it into the dash. Thanks guys. Quote
monte70car Posted September 12, 2015 Posted September 12, 2015 Yes use a 9volt battery and you can test each light before going in the cluster. To test in the cluster you need to trace the light circuit in the PCB and you can use the same 9volt battery to power the whole circuit. So you need one 9volt, two piece of wire, clips to hold one end of the wire to the battery or a 9volt battery plug. Quote
Enigmatic Posted September 13, 2015 Author Posted September 13, 2015 Thanks man! Did not think of that..but that helps alot. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.