AMD quarter panel

[Denny]

has anyone used AMD 1/4 panels wondering about quality and fit

[Rob Peters]

From what I have heard the AMD quarters of good quality and fit.

rob

[MC1of80]

Just as good, if not better than originals. (pre COVID) 

[67ss4speed]

2 hours ago, Denny said:

has anyone used AMD 1/4 panels wondering about quality and fit

Yes, they fit good. 
self performed work.

[71SSclone]

Im using 1 AMD and 1 NOS 1/4 panel on my body job, and my bodyman was very impressed with the fit of the AMD compared to the NOS. 

[Denny]

great thanks to all for your input,ordered amds today,going to attempt installation. any pointers would be appreciated

[Jared Richey]

And some NOS are garbage just ran into this on a 67 camaro. It was a late run. NORS with a GM sticker.  Made 20 years later. Fit awful 

[BobW]

Does anyone have a damaged right rear quarter? I could use the lower section from the wheel well back, or at a minimum the recessed marker light section.

[Montemedic]

AMD does make very nice partial and full quarter panels. Since our Monte’s tend rust around the wheel well lip and behind them, you can cut out what you need for new replacement metal or replace with a partial or full panel. 

[BobW]

2 hours ago, Montemedic said:

AMD does make very nice partial and full quarter panels. Since our Monte’s tend rust around the wheel well lip and behind them, you can cut out what you need for new replacement metal or replace with a partial or full panel. 

Somewhere along the line this section was repaired with metal, but they just cut a hole in the flat and screwed the marker kight on. Obviously the trim didn'tfit very well. This section is solid,aside from the F'd up hole.

 

If I cant find a suitable piece, I'll end up getting a 'skin' and using the section I need.

[Jared Richey]

AMD only makes FULL

The 80% is a dynacorn part and all that was available for years.