aluminum heads

[71monteme]

are ready to get install, hopefully this week.

 

can't wait to see what they will do.

 

thanh

[Andy's Auto]

Thanh, what are they, besides alunum square ports?

 

Andy

[Ian]

Nice!

[Heckeng]

I'm jealous. What is the rest of the build?

[71monteme]

Thanh, what are they, besides alunum square ports?

 

Andy

 

they are reworked pro comp heads, nothing but the heads themselves are procomp. 320cc intake runner and 115cc combustion chamber. 2.25/1.88 valves.

they're goimg on my 496bbc with 12:1compression. custom grind solid roller cam.

hope it gets me in the 10's on motor.

[TN454Monte]

Nice, looking forward to seeing how they work out!

[BigBlockMonte]

I use pro comp heads. Only issue i had was the springs that came with them. One broke on me. I switched to comp 924-16 and all good. The heads really woke my car up. so i think you'll be happy with them. and for under a grand you really can't beat them. good luck!

[Jared Richey]

I thought they might be Pro-Comp heads, nothing wrong with them as for as I'm concerned.

My engine builder ordered them unassembled and done the valve job and assembly himself on my engine.

 

A friend of mine just installed a set on his Camaro that he's raced for 25 years, and poof right back into the 7.20s where the car used to run.

[71monteme]

well with the machine work, matching springs to my cam, guides and studs, all came to about $1400.00. still not bad for the power gain and weight lost on the front end.

they are not bad if you don't use any of the hardware from procomp.

[BigBlockMonte]

just curious to what pushrods your using. Thanks

[71monteme]

just curious to what pushrods your using. Thanks

i can't remember for sure but i believe they are comp cam 7/16 push rods.

 

thanh