Jump to content

Recommended Posts

Posted
Originally Posted By: black07ss
Originally Posted By: footballubet
Got it pulled away from it's winter resting spot. Need room around it so I can install the remote power door locks and trunk release that are in our Group Buy. I'll be doing the install and giving it my review for everybody else.

 

Sounds great!! I can't wait for you to do mine lol

 

You better hurry up and get your's done before I'm so old I won't remember how to! lol

 

dittolol

  • Replies 1.5k
  • Created
  • Last Reply

Top Posters In This Topic

Posted

It took a while due to health but and here is the good one... got the Rear Fiber Optics put in the convertible monte today and next is the Electro Tip wipers to go in...... smile load this sucker up.....

Darren.

Posted

Got my MSD box all mounted and wired up. What a difference.

 

 

Nygel

Posted

Started it today and let it run for awhile. Last time I drove it was just before Thanksgiving. It was like Groundhog Day. Warm but no shadow, so hopefully we'll be back on the road soon. We have to wait until they clean up all the sand from the roads first. My street looks like a beach. Come on Spring !!!

Posted

After Super Storm Sandy she got water up to rugs so they came out along with the insulation.Changed starter and wires.She wont start unless i give her a good boost. New battery did'nt help nor did a new horn relay. Will have to trace everything down as soon as warm weather comes. Garage too small to work in.

Posted

After Super Storm Sandy hit she got water up to the rugs.Took the rugs and insulation out and washed her undercarraige.Changed battery,cables and starter.Wont start unless i give her a good boost.Changed the horn relay and cleaned connections to no avail.

Will have to wait for warm weather to trace the problem down. Garage too small to work in Took her on the road this week and everything else semms ok.

Posted

Got the new Monte off the carrier today. Got is washed and now getting into checking it all out. Seems to be a really sound car. 103,000 miles. Drivetrain was rebuilt at 92,000. Outside of a noisy speedo it seems to run out really good. I'm ready for the Western Meet. Does need a new steering wheel. Anyone?

Posted

Got the tank, pre filter and pump installed and both the feed and return lines running forward for the fuel system upgrade.IMG_0525_zps9159036f.jpg

Posted

that gas tank looks clean and delicious! Could I do something like that on a stock setup?

Posted

Just watched it sit there while it rained all day. Darn weather. Suppose to be in the 60s tomorrow and will get it out for some cruising. It's such a joy to drive. Love My Monte.

Posted

I like it... looking good! Keep up the good work.. I'm baking bread right now!! Nice hot weather today! Thumbs-up!

Guest 1970 James Byers
Posted

Didn;t do anything to my monte either accept look at.

Posted

I came across some nice plates at a swap meet this morning I had to get them because they have 454 on them( don't have a 454 yet but that's the plan my Dads 72 monte has NF 454 as his plates)

IMG_20130303_1115552_zps63d2be4f.jpg

Posted

Sweet plate!

 

I tested the motors on all the window regulators I bought from Vince. Looking to install today.

Posted

Tried to find the build sheet from an SS I recently bought (Van Nuys SS). Looked under the seats both front/back, console, under the dash pad, under the carpet, took door panels off, took off the plastic backs of the bucket seats and found nothing..BOOOOOO!!!

 

Going to look in headliner when we switch that out at the upholstery shop and will drop the gas tank next week. Still have hope, but not looking good.

 

Troy

Posted

Bummer, Troy!

 

But there's still hope ... some of the better ones are found above the gas tank. Also, some have been found between the seat upholstery and the seat padding, so you may score yet. Keep the faith!

 

Good luck!

Posted

I hate to take the seat upholstery apart as the interior is so nice and I have no background in taking seat covers off and reupholstering them. I'm banking on the gas tank, fingers crossed.

 

Troy

Posted

I got the engine bay box mounted with out the fan and found out my upper bolt hold in the firewall is to big for the bolt frown. Waiting on the gloss black paint to dry on the inside box on the side you can see. I made a bracket to hold the heater core in place slowly getting closer.

Posted

got the 4 speed all loaded up with things for the headliner install, now I have to get it in the trailer

 

couldn't drop the engine and tranny in, it's on the other side and the cherry picker won't fit thru the door with the legs down mad

Posted

Received the new vinyl top on Saturday. Going to the shop for installation this week.

Posted

Found the problem with not starting.

Had new starter and solenoid went bad " INTERNAL SOLENOID".

Switched the solenoid from old starter & she started right up

Posted

Picked up my custom covered front seats. smile

 

421557_10200135259358355_1209763142_n.jp

Guest
This topic is now closed to further replies.

×
×
  • Create New...