[ss 12bolt rear end]

the guy rebuilding my orig. 12 bolt from my 70 monte told me my bearing surfaces were shot ,so i pulled axles out of a 72 monte parts car i have but after noticed the rear cover is smooth also 72 axles were heldin with 4 flange bolts by the backingplate  thought all 12 bolts were held in by c clips?

[ss 12bolt rear end]

thanks for all the info!  very helpfull

[ss 12bolt rear end]

whats bop mean?

 

[ss 12bolt rear end]

is there a differance in the 12bolts put in the 70 ss from other 12 bolts?

 

[hole size for sway bar a frame mounts]

anyone know the size of the hole in the lower a frame for the bolt that the swaybar ataches? Mine are egged I did weld them to round again but wonder if they should be sized to the studbolt or if theres abushing? any help appreciated

[hole size for sway bar a frame mounts]

anyone know the size of the hole in the lower a frame for the bolt that the swaybar ataches? Mine are egged I did weld them to round again but wonder if they should be sized to the studbolt or if theres abushing? any help appreciated

[Mega Parts Post Update Jan 2024]

thanks

[Mega Parts Post Update Jan 2024]

looking for 70 clean fenders

[Mega Parts Post Update Jan 2024]

im in need70 fenders

[monte frames]

thanks ill chehk that again tommorow, if i remember correctly the 70 frame measured 39 3/4 & the 72 donor car 39 3/8 at the rad , support .I also will double check diaganal measurements. thanks to all who responded

[monte frames]

thanks guys , does anyone have correct frame dimmensions out there?

[monte frames]

Anyone know if 70 frames measure the same as 72? My 70 that I'm rebuilding measures 3/4" wider than the 72 frame that I have, at the core support mount holes. My 70 is a 454 car

[454 maximum bore]

thanks, everyones opinion appreciated.

[454 maximum bore]

Hi ,looking for info ,I have a 70 ss 454 with rust pitting on cylinder walls .Can anyone tell me how far these blocks can safely be bored. Also any good updates for these motors appreciated.Debaeting rebuilding or going with a crate motor.

[engine id]

ya thats what I should have said ,was wondering if there is some way to tell if the crank is forged or not by the motor no. Thought that i had read somewere that there were no 4 bolt mains in 70? thanks. Does anyone know of a site to help decode these nombers?

[engine id]

can anyone tell me how to tell if my 454 has a steel crank by the numbers on the block?

[need some advice on replaceing trunk .and poss. roof]

thanks guys

[need some advice on replaceing trunk .and poss. roof]

thanks,going to replace the trunk floor but all ready removed or cut all body bolts. most of the cagenuts spun loose of the welds so need to replace these,iam guessing i should replace the cagenuts and rebolt body to the frame first?

[need some advice on replaceing trunk .and poss. roof]

any instructions around for relacing trunk pannel and roof will i need a rotissery? if so what should i look for in a rotissery?   thanks

[70 fenders]

thanks again to everyone     great help

 

[70 fenders]

thanks to everyone who chimed in very hepfull,seems one could use 72 fenders on a 70 with shims?

 

[70 fenders]

any one tell me if 70 monte fenders are the same as 72?   thank