Jump to content

72MC

Members
  • Posts

    673
  • Joined

  • Last visited

  • Days Won

    8

Image Comments posted by 72MC

  1. Thank you. The headers are Patriot with 2" primaries. Plug wires are MSD that I prepared myself using the straight boots that can been angled based on the need. The angles range from 180*/straight to 135*. Yes they are factory heads. I cleaned/smoothed all the mold marks off. - Dave

  2. Aaron, I'm not trying to bust your chops here but your final step is wrong, or should I say incomplete.

     

    After torqueing the spindle nut to 12 ft lbs, the rotor is to be spun both forward and backwards several times while re-torqueing the spindle nut to 12 ft lbs. After this has been done, the spindle nut is to be loosened just enough to spin the nut by hand. The spindle nut is to then be tighten by hand as far as it will go. Then you insert the cotter pin.

     

    Tightening the spindle nut to 12 ft lbs and leaving it that tight will cause premature wear on the bearing. Just thought you would like to know. - Dave

×
×
  • Create New...