-
Posts
13 -
Joined
-
Last visited
Content Type
Profiles
Articles
Forums
Gallery
Events
Posts posted by samstevens
-
-
Trying to find a set. Where can I get them. Tried opgi, ss396, and few other places. All say they are on back order.
-
Where can I get a set?
-
Making an a/c harness a non a/c harness. I know my plugs won't work. I plan on using insulated female quick disconnect's. So, I need to know what wires go where on switch, resistor, and do I use a relay?
-
-
Hello
in New Members
5 hours ago, jft69z said:Here are some schematics for a non-AC car. One set is from Mitchell, the other is from the GM service manual. They do not use a relay for a standard heat vehicle, it's a real basic circuit compared to an A/C system. The plug for the internal blower resistor is inside the car already, even on an A/C car. You'll still need to trace some wires, but everything should be there to make it work. Did you get a heat only control panel too, I'm not sure if I read that already?
Print out the pages & tape them together on the side. It'll make it easier to trace wires from inside to the engine compartment.
EDIT: Added the same prints, but highlighted the circuits.
monte schematics.pdf 2.42 MB · 0 downloads 72 schematic.pdf 607.09 kB · 0 downloads
72 schematic- highlighted.pdf 659.52 kB · 1 download monte schematics-highlighted.pdf 2.47 MB · 0 downloads
Yes I have the non a/c control panel.for some reason it won't let me download the schematics. Will you send them to my email. samstevens1969@hotmail.com.
-
Hello
in New Members
13 minutes ago, jft69z said:Did you change out the under dash A/C unit to the standard heater only type unit? If so, the blower motor resistor should be mounted inside the car now?
I actually converted the box. Removed all vacuum hook ups and installed manual cables. The harness I have is for a a/c car. Which the blower switch is different. What I need to know is how to modify the harness, do I still use a relay. I did cut and mount the resistor in the heater box, and yes it is inside of the car.
-
Hello
in New Members
5 hours ago, Brew said:Well Brew since I deleted everything a/c. The non a/c fan switch is different than the standard one. I have the same wiring diagram. But with the delete I think alot less wires are needed. And I'm not sure if I need the relay
-
Hello
in New Members
1 hour ago, MC1of80 said:Welcome Sam!! She looks good! What's the issue?? Lol
Did an a/c delete now I'm trying to figure out how to do the wiring for the blower motor. I switched over to a manual control for the flaps.
-
Hello
in New Members
5 hours ago, Dtret said:Welcome. Just ask away. We will try to help.
Thanks
-
Hello
in New Members
1 minute ago, Canuck said:Welcome! Nice 72. This is a great group here.
Thanks hopefully I can get some helpful info to get her going
-
I have removed my a/c and installed a delete plate that allows for my blower motor. I have gutted the heater box under dash and installed manual cables to the flaps.I also have the correct non a/c control panel for the dash. I'm now starting on the wiring harness. I do have a diagram but it is for a vehicle with a/c. I need to know how to wire the blower switch, relay, ect... Any and all advice is appreciated.
-
Hello
in New Members
Front floor pans
in Auto Body Repair
Posted
Thanks everyone I found a set!