lastss
-
Posts
337 -
Joined
-
Last visited
-
Days Won
11
Content Type
Profiles
Articles
Forums
Gallery
Events
Posts posted by lastss
-
-
shim it with a washer or two?
-
I have a couple of NOS grills and they are Argent silver in that area.
-
Most of the reviews were on Summitt Racing site and was premature failure.
-
Petronics has issues
-
From what I read a few months back with quality control issues, I went with Accell at a much less price through Summitt Racing. Any Veterans can ask for a discount, must ask over the phone.
-
Nice, very interesting. Thanks for sharing.
-
That’s 100% correct the one to the right is Monte Carlo.
-
The picture shows the 2 piece one on left and the right side picture shows the correct one it’s one piece, my pics not the best.
-
Ok I’m adding a picture from GM As you can see the correct heat stove for our SS is part number 3976061 and a flex heat tube. No elbow. And a clamp. BTW there was one on eBay just a day or so ago for $400 not mine. Hope this clears everything up. Bob
-
Radio shack and I don’t remember what it was, I had tried a few different ones. I do think I used the base resistance reading on the replacement one and added the more to what it’s was originally but I didn’t make any notes and memory is just not there.m
-
I put a resister in the wire at the sensor to get mine to read correctly.
-
After months of waiting,sent me covers with crooked stitching,glue overspray on rear seat cover, tried to get me to take a $100 discount. Big pain. Sent it all back.
-
We’re did you buy the tool set up for measuring the pinion depth?
-
Awesome, watch all the time, what a treat.
-
You need to tighten the nut using the old bar type torque wrench until it takes I think 40-45 lbs reading to turn the rear end. Look at some websites that sell posi units, like Yukon.
-
Awesome, your work is better than factory.
-
2
-
-
Also note these units even when working properly are very very slow to pump up to full pressure, that's why GM suggest to air air from an outside source to cut down on pump up time.
-
The GM tech books state to testityou should first use the fast fill valve and put in 100 lbs of air then use a vacuum source and it should pump up to about 120 lbs. I test my rebuilds of the car.with no compressed air. I have a guage I put on the output side and vacuum pump on the inlet. If working properly you will hear a sort of tick, tick sound back and forth over and over. A steady no tick means it's not working. Also to test the tank etc for leaks you pressurize the unit and have a vacuum hose attached from the inlet filter connection to the vacuum inlet fitting both tight fit, and submerge the whole unit in a bucket of water, look for any bubbles of course.
-
It works of the pcv valve hose which is Vacuum, if you pressurized the intake hose you most likely damaged it.
-
Awesome, high honor. Congratulations
-
Awesome.
-
Funny I purposely didn't repaint my steering column because of all the 46 yrs of key scratches. It only original once. Lol
-
Just a short note to a long 6 month Nightmare. To date I have been lied too, received multiple excuses and damaged seat cover even with Glue on them Im was asked to Removed which I refused. Corked stiches Failed return pick ups etc etc.
-
They are awesome and flawless, The artist whatever he makes.
71 SS
in SS 454
Posted
I used Eastwood for over a decade, key is to blast them washed them in acetone, bakethem to remove any moisture and then coat them and bake them again. Mine been on over a decade and only requires a little touch up here and there one e a yr.