lastss
-
Posts
337 -
Joined
-
Last visited
-
Days Won
11
Content Type
Profiles
Articles
Forums
Gallery
Events
Posts posted by lastss
-
-
Update, Well its didn't work under the hood, However it did work directly at the gauge Hooray & Many Thanks to all its a neat trick that saves a lot of time/lobor Many Thanks Bob
-
Well didn't work at the battery, Ill try at the gauge. Maybe Bruce is correct the needle came loose. Thanks Bob
-
I wonder if U could un hook the battery terminals & do it that way?
-
so you hook up a aaa battery to the back of gauge & just do a quick hit with the voltage to move the needle?
-
That's AMP
-
Anyone know what would cause a factory amp needle to turn/point down?? was working fine then next I notice its pointing towards the floor does move a little when load changes.
-
-
Stuck Thermostat maybe?
-
Mine has one on each front fender inside. Found them when I removed the inner fender ext. no longer complete & I haven't touched them as they are falling apart. have one from gas tank & under pass side carpet with a couple extra screws & empty chewing tobacco pouch #7. Good luck
-
I Like it as shown Orginal
-
You use barrel nuts not screw on nuts.
-
1
-
-
So Sorry for your loss. Prayers sent.
-
Pictures of air cleaner & heat stove would help
-
Many Thanks
-
Can anyone tell me from their correct 402 air cleaner what size dia is the metal stub at bottom of the snorkel were the flex hose/ elbow hooks up to is. Like 1.5 inch 2.0 inch example Thanks Bob
-
If your temperature stays within 10 degrees of thermostat your system is in great shape, I used an temp probe to measure mine at operating temp & put in a resistor in line at sender to have it read correctly resistor at radio shack cheap. It does vary at time of heavy traffic etc, but not a fast change.
-
points inside the regulator need adjustment.
-
Check any Used tires & also new ones for the 4 digit date code like 2515 is 25th week of 2015 if more than a 3 months old forget it, too dangerious. check ot U tube video's under tread separation.
-
Absolutely need to flush out all the old r12 oil. no need to replace compressor. Recalibrate poa for 134A or take it out & put in a poa eliminate kit & wire in the pressure cycling switch & re fill 85% of the total r12 rating can't remember at the moment like 85% of 3lbs.
-
Have a Qualified tech check it first, Then make a plan what it needs, Don't guess.
-
Jump out regulator terminal plug a & f terminal should put out full amps at 1500 rpms
-
use Popsicle sticks, worked for me or clothes pins wood of course.
-
Hagerty insured my ss for 45K no appraisal.bob PS that was 14 yrs ago & still the same today.
-
Great send me a picture. I have an old racing tire from Richard petty driving school you can have, Just pay shipping, Have glass top made. Bob
SBC 400 making noise
in Engine Tech
Posted
Yes for sure, Run some marvels mystery oil though it & change the oil may take a few time also good in the fuel tank.