sendo

454

will have to take it off and measure it

changing pulleys to add a/c to my car and ran into a problem with the new crankshaft pulley hitting the fan pulley. cant find a 3 groove pulley that is the same size as the original 2 groove. is there one or is there a different size fan pulley?

hoses and condenser original air group,evap the parts place, compressor rock auto, drier and valve ebay

all new, evap, parallel condenser, hoses, drier, expansion valve, a6 compressor want to go 134

the instruction sheet that came with my compressor say, if the amount of oil removed from the old compressor is less then 2.5 add 2.5 to the new , if it is greater 2.5 add the same amount. but this is a new install

all new

hello, how much pag oil do I put in a new a/c system and jow much feon?

No car is still apart, the only wire that look like was wrong is the R from the starter, the distributor was connected to negative and was the tach, the positive has a black wire and the condenser

So I guess that wire from the tsc was just hanging there because I don’t have one

But it was connected to negative side

okay so i traced the two wires, 1 went to the R on the starter, don't make sense supposed to go to the positive, I didn't loosen the positive side when I took it apart so i know it was not hooked up to the positive side, car started and ran good before I took it apart, does that wire really matter? wire 2 went to the TSC not sure if it was connected to the negative side of the coil but it in the area with a fork so I assume it was connected there, looking at the diagram it connects to something I cant figure out in the red circle. thanks for all the help, Sendo

yes i have that its on the positive side, trying to figure out the negative side

so 1 for tech, 2 for distributor, what's 3?

hello, going to start putting my car back together, wish I would have took pictures because its been a while. So when I went to put the brown tech wire back on the coil I found three other wires there, one from the distributor and two others that are tape into the harness. does four wires on the negative side of the coil sounds right? don't want to tear up the harness to trace wires if i don't have to. the car has points if that matter thanks, Sendo

hello, has anyone used these rebuild kit, if so how do they look?

OMG!! how do you get the rear regulators in without denting the quarter panel from inside

thanks Dennis I have three washer type mounting tabs on both sides coming out the ribbon, do the wire run under back seat or the bottom seat?

thanks Doug, so where does the red arrows bolt into and the green arrow has a plastic stub, does it plug into the hole that it is at? thanks, Sendo

does anyone have picture of how the rear harness is routed?

so many different model numbers for four seasons and ac delco which one do I get?

Hello Andy, are you willing to sell one ? the store bought one are they rounded to clear the bracket and do they have the muffler? thanks, Sendo

thanks Andrew, another thing is how the hose enter the block I see back and the other top & bottom?

I went to old air products website and they have the same hose for all monte's, but if you look at chevelle and el camino they have two different hoses for BB and SB. so there must be a difference in hose for a SB Monte and BB Monte too

https://www.ebay.com/itm/1970-72-MONTE-CARLO-A-C-COMPRESSOR-HOSE-MANIFOLD-ASSEMBLY-AC-Air-Conditioning/361297894286?fits=Year%3A1970|Model%3AMonte+Carlo&hash=item541f085b8e:g:xW0AAOSwNSxVVj-p here is the link to ebay