Jump to content

Canuck

Administrators
  • Posts

    6,148
  • Joined

  • Last visited

  • Days Won

    217

Everything posted by Canuck

  1. From the album: 2010 Western Meet - The Dalles, OR

    Rosa and Keith with their Best Interior award
  2. I just ordered a set for my 72. I wish i knew of these when I was restoring the 70. I purchased the original type for the 70 from a Chevy dealer back in 2000. I tried the dealer for the original type today but they could not get them anymore.
  3. I run BFG 255/60/15s on my 70 Monte (all original drivetrain) and my speedo reads about 7% too high. I think it's because my tires are a slightly smaller diameter than stock. I tested it during my drive to the western Meet using the mile markers. I tested it several time during the drive and got the same 7% result each time. You are running 245/60/15s which would throw it off even further (11% in your case).
  4. Some photos from the 2010 Northwest Motorfest I found: http://aaronflake.zenfolio.com/p22781751/hb44959#hd11a88e This looks to be during the Capital City Cruise on Saturday evening.
  5. Is this you fixing the wiring during the drive down to the meet? Looks like Owen was on spare tire duty.
  6. Here is the club participation award the FGMCC received at the Western Meet All the members who attended the event signed the back Link to album: http://s924.photobucket.com/albums/ad81/Aaron70Monte/Car%20Shows/2010%20FGMCC%20Western%20Meet/
  7. From the album: 72 Wheel Bearing Replacement

    Installed the rotor back on the car and put the washer on. After that, install the nut and tighten (see Dave's comments below). Also install a new cotter pin. Job is done! Did you have as much fun as I did? [edited by Aaron July 31/11]
  8. From the album: 72 Wheel Bearing Replacement

    Packed and installed the outer bearing.
  9. From the album: 72 Wheel Bearing Replacement

    I hammered in the new inner seal.
×
×
  • Create New...