bodene Posted April 26, 2015 Share Posted April 26, 2015 putting hei dist in need to know if one of the two wires going to coil pos. terminal is 12 volts off the ignition or are both restricted. I keep hearing I need to run wire to fuse box ignition terminal. just thought I would ask. Quote Link to comment Share on other sites More sharing options...
Sam (Bones) Posted April 26, 2015 Share Posted April 26, 2015 one is full battery voltage only when the starter is engaged! the other is a resistance wire you'll need to run another wire from the ignition circuit or....remove the resistance wire from the harness and replace it with a 12 gauge wire all the back to the fuse block (engine side of firewall) Quote Link to comment Share on other sites More sharing options...
bodene Posted April 26, 2015 Author Share Posted April 26, 2015 I guess I knew that! I was just hoping !! guess i'll run it to fuse box! thanks! Quote Link to comment Share on other sites More sharing options...
Sam (Bones) Posted April 26, 2015 Share Posted April 26, 2015 but make sure you use the ignition circuit!!!! if you don't....it won't start until you let off on the key, only the ignition circuit gets power while cranking the starter Quote Link to comment Share on other sites More sharing options...
bodene Posted April 26, 2015 Author Share Posted April 26, 2015 thank's sam ! working on it now Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.