kc8oye Posted April 10, 2008 Share Posted April 10, 2008 Picked up a Hayden kit from the local parts store, i was going to go bigger, but budget didn't allow for it right now, and I needed to replace my old one ASAP, because it had rubbed thru one of the tubes on the end and was spraying fluid. I made room for the cooler hoses this time, using a 1-1/2" hole cutter, the holes could have been smaller, but I only had 1-1/2" and 2-1/2" cutters. with the re-routed hoses, and the radiator being set back, it forced me to mvoe the cooler over towards the middle of the rad so the hoses wouldn't be stressed. .which worked it pretty well because now about 1/2 of the trans cooler is infront of the electric fan Quote Link to comment Share on other sites More sharing options...
AL M Posted April 10, 2008 Share Posted April 10, 2008 Looking good!...maybe some type of rubber grommet to prevent rubbing against the metal edges?...Al Quote Link to comment Share on other sites More sharing options...
kc8oye Posted April 11, 2008 Author Share Posted April 11, 2008 yeah.. Harbor Freight has a rubber grommet set I'm gonna take a peak at. i'd prefer to use a grommet for a tidier look if u didn't notice, there's no radiator grill right now LOL.. so it's not getting driven a whole lot right now. Quote Link to comment Share on other sites More sharing options...
kc8oye Posted April 11, 2008 Author Share Posted April 11, 2008 i found a place that sells just the right grommet I need.. but they're $3.50 EACH!!! oh well.. guess i need them. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.