Jump to content
NJMONTE

350 to 200r4

Recommended Posts

Its probably been posted several times , but would a conversion from one to the other be basically bolt

on regarding driveshaft length cross member position ? could I use the same flex plate?

I know I would need a tvs cable bracket at the carb ,  and how about the gear indicator position on the  dash ?

and shifter   (column shift ) have an 86 SS and took it off the computer to control the lockup with a vacuum switch

 with separate  switch to lockup up when it shifts in to 4th gear how would it work with a 2:73 gear my 86 is 3:73

Share this post


Link to post
Share on other sites

Yes, it is a direct fit. I have the 200r4 in mine, and you just need the new detent plate (shiftworks or a forum member has them) and cable. If have a console the proper plate is available, but I cannot speak for the column shift indicators. Driveshaft is the same length too.

Share this post


Link to post
Share on other sites

Hmmm. I had to shorten the driveshaft on mine by about 1.5 inches. I have a 12 bolt rear end if that makes a difference. 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...