vince

Sorry I don't quite follow you!! How will tie the two pc's together? or would it be easier to get a 5g flash drive and cut and paste?

I got a new PC and I would like to know how to transfer my doc, Music, Videos and some programs from old PC to new one. Some one had mention master / slave hard drives?

If I remember correctly Someone in the club made some videos on how to do this. I might have them

I am going to bring this thread only because I have some issues with my new tail lights. first question: After cutting off the stock light sockets do we tie the two black ground wires together with the green wire from LED lights and a separate wire that ties to the body as a ground? Or do we only use one GM ground wire with body ground. and cap off the second wire? The same questions goes for the Yellow wire on the driver side and the green GM wire on the passenger side. Second question: will the front parking lights have an effect on the LED tail lights? When I turn on the lights I have no parking lights Is there a separate fuse for them? We can rule out bad bulbs because they are new. more Questions to follow.

It's been a while since I took them off, but if I remember I used a shop rag against the car and preyed them off with a plastic putty knife. It's Probably not the best methiod to do, but it worked for me. The pegs on the emblems seem to have a spring loaded wire that expands once in the hole.

Tim at first I tried it that way but my eye sight is getting weaker with age. Here is the out come.

Thanks Everyone for your advise. I used the technique above and everything turned out good. I was very happy with the outcome

Thanks guys I will give it try this week and let you know how it turns out.

fine grit emery paper, liquid masking tape, towel and reducer, All are excellent ideas. I was thinking around the same lines only using acetone or paint thinner. Anything special for the paint? or will plain high gloss rattle can paint work?

Has anyone restored these before? They are in good shape except for the black in the back ground. any ideas?

I know this tread is a little old but I have a few questions. Where is a good source to get these rubber bumpers? I assume that we are talking about the ones on the fenders? Or the two on the radiator support?

I ran House call and AVG and no viruses were found. But I still get this window pop up saying that Microsoft firewall has blocked Win32.Zafi.B. any other suggestions?

I keep getting this message that Win32.Zafi.B is on my PC. When I run my anti-virus(Avast)I does not find anything. Is this a real virus or not? Is there a web site that shows current viruses?

Loading direct X fixed the problem. Thanks for your help.

The camera is a cheapo. My youngest son bought for my daughter and they really want me to make it work. I checked the direct files and the one that I need is not listed. I guess I will have to reload direct x and hope that it shows up.

I am not sure, i looked at the properties for directx folder and can't find anything. where else should I look?

My daughter got a digital camera for Christmas and the installation is asking for a kstvtune.ax driver. Dose anyone know where I can find it?

Great pictures, thanks for sharing them. vince

Sam, Is this seal located where the converter slides into the transmission? and Is the seal attached to the trasmission or converter? Sorry for all the lame questions, This is my first attempt of doing this.

thanks I keep that in mind.

Wow that is some good advice. I want to get it done right the first time, so off I go to get a trans jack.