1Bad454 Posted April 24 Share Posted April 24 Hey guys I'm not having any luck finding the J nuts and screws for the side markers. Also I can't seem to locate the mounting hardware for the tail lamp lenses and bezels. Your help would be greatly appreciated. Quote Link to comment Share on other sites More sharing options...
jft69z Posted April 24 Share Posted April 24 AMK will have all that stuff. Side Marker: https://www.amkproducts.com/search-result/?ser=G-4201 Tail lamp bezels (includes screws and nylon nuts : https://www.amkproducts.com/search-result/?ser=G-4204 3 Quote Link to comment Share on other sites More sharing options...
1Bad454 Posted April 24 Author Share Posted April 24 9 minutes ago, jft69z said: AMK will have all that stuff. Thank you Joe! I went through my AMK kit and didn't see those items. It seems that I must have lost one item and ended up needing a few others that were not included in my kit. Quote Link to comment Share on other sites More sharing options...
jft69z Posted April 24 Share Posted April 24 1 hour ago, 1Bad454 said: Thank you Joe! I went through my AMK kit and didn't see those items. It seems that I must have lost one item and ended up needing a few others that were not included in my kit. I'm still looking into the side marker ones, so don't order anything just yet. The tail light numbers are good though. It says this number below is for the rear side markers, but I'm trying to confirm it with the assembly manual: https://www.amkproducts.com/search-result/?ser=g-4228 EDIT: For the front markers, your assembly manual will be page 12C-3, items 2 & 3. Those numbers look good for the G-4201 kit. I don't believe them in regards to the rear, I think just using the same type screws as the front markers will work fine (B-12152) So, I'd either order 2 of the G-4201 ($3.50 each), or get some bulk kits, with all the fasteners, and some left over. J-nuts (8 of them - $4): https://www.amkproducts.com/bulk-fasteners-products/?Product_ID=12245 Screws (12 of them - $4): https://www.amkproducts.com/search-result/?ser=B-12152 Realistically though, NAPA would have J-nuts that work, plus some #8 screws. Would be a lot cheaper once you figure in shipping. 3 Quote Link to comment Share on other sites More sharing options...
Blackhawk Posted April 24 Share Posted April 24 On my car it used the same screws front and back, but the rear markers used nylon nuts similar to the tail light bezels. I believe they were a different size than anything that I had from the front or rear light hardware kits, I can see if I still have the package this weekend. I just measured the holes and did some measuring at Napa until I found the right one. 1 Quote Link to comment Share on other sites More sharing options...
1Bad454 Posted April 24 Author Share Posted April 24 Thank you gentlemen. It's been a bit confusing to say the least. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.