bob 71

ive got the place for an accidental fire

i saw steves hood looks really good

i used black/aqua then satin clear coat. rattle cans from the parts place. about 4 or 5 years ago looks ok

as cbolt said lite to lite they are good. highway not so good. 355 or 342 good street/ cruising gears. i have 411 and just put in gear vendor overdrive knocks it down to 320 when engauged

gear vendor working good. i like hitting the button and dropping about 6 or 8 hundred rpms at same speed. my pocket likes it too.

ive got a blue print small block engine with dual plane air gap intake 2 inch spacer edelbrock carb 3 inch air filter no fitment problem

went to a spring dust off show/cruise only monte there. went to a new thursday nite cruise me plus 2 other first gens

its rolling. was a little tough to put in. had to section apiece of floor for clearance gear vendors said clearance problem might be from original body mounts. measured drive shaft length wrong had to have new shaft made. have a vibration need to check drive line angles starting with balancer on engine, back of o/d unit, drive shaft , pinion yoke and figure out how much height difference between front to rear

yea but its a good time

went to syracuse car show on sunday saw some trailer queens and some from cruise nites/shows. went to buffalo car show on saturday saw some trailer queens some drag cars some nice street cars alot more than syracuse.

looking good

sorry to take so long to reply. i know chris at terrys transmission everything still good there

i dont know much more than already said. dont know anybody using that set up. seems like it should work on paper but you know how that goes. probably heavier with brake on back. best bet talk to trans shop.

hood looks good. good luck with surgery

went out at 830 last nite plowed 3 hrs got up at 4 this morning plowed 3hrs went out at noon plowed 2hrs this is fun NOT. lucky i was off from work today?

here in syracuse i see a lot of damage like mentioned from mice. got my wifes car in the garage. dennis when is squirrel season for the large pointed head ones they look tastey

nice car dudes a trip a cross of mister rodgers and archie bunker

i feel your pain i dont like snow either we didnt get as much in syracuse as you guys did but it still sucks spending 3 hours in the truck plowing

depending on how far you want to go get as much positive caster as possible with 1/2 degree difference side to side (usually 1/2 more positive on right) and go as far negative camber while staying within tolerance and set toe to prefered specs car will handle as best as possible with out changing suspension parts

looks good glad to see you painted master cylinder or used an aluminum one i used same brake lines on my car thanks for close up of line lock no trying to nit pick but it looks like you ran rite front brake line under motor not around front of car

i feel your pain steve im down to 10 mpg with daily driving and lite plowing cant wait for this weekend

i would also be interested depending on cost

im with you steve. put about 15 miles today. first chance to drive it after a little work

was the meds and food for her or you. just kidding glad things are going good

lookin good hope to see next summer